aircraft aluminum tubing bend radius chart

If the steel has a tensile reduction value of 10 percent, divide 50 by that value: 50/10 = 5.

There’s a rule of thumb to determine a steel’s minimum bend radius: Divide 50 by the material’s tensile reduction percentage as specified by your supplier.

The minimum diameter is the smallest diameter you desire to roll your material into because it is a great driving factor for the size of the machine that will be appropriate for your workshop’s certain needs.

Read More: Plate Rolling: Process, Basics, Tips, And 11 Key Points The grain can be seen by looking at a new piece of sheet metal and noticing the direction of visible lines going from one end to the other. Grain direction is often specified on stainless steel in order to achieve minimum bend radius or to control spring back. Grain Direction is not to be confused with surface finishes made by sanding or other finishing operations. Grain Direction is formed in metal in the direction in which the sheet was rolled at the steel mill. Since commercial sheet metal bending can be done with less concern for stresses caused during forming operation, the radius can be near zero for thin sheet metal. The bend radii listed are standard minimum if manufacturing for aircraft and aerospace applications.

AC 43.The minimum bend radius data shown in these charts is measured to the inside of the bend.

it is not contrary to manufacturer’s data. it is directly applicable to the repair being made andĬ. the user has determined that it is appropriate to the product being repaired ī. The repair data may also be used as approved data, and the AC chapter, page, and paragraph listed in block 8 of FAA form 337 when:Ī. The repairs identified in this AC may only be used as a basis for FAA approval for major repairs.

This data generally pertains to minor repairs. This advisory circular (AC) contains methods, techniques, and practices acceptable to the Administrator for the inspection and repair of nonpressurized areas of civil aircraft, only when there are no manufacturer repair or maintenance instructions. Recreational Flyers & Modeler Community-Based OrganizationsįAA Home ▸ Regulations & Policies ▸ Advisory Circulars ( ACs) ▸ĪC 43.13-1B - Acceptable Methods, Techniques, and Practices - Aircraft Inspection and Repair ĭocument Information Number 43.13-1B Title Acceptable Methods, Techniques, and Practices - Aircraft Inspection and Repair Status Active Date issued Office of Primary Responsibility AFS-350 Description.Critical Infrastructure & Public Venues.Certificated Remote Pilots including Commercial Operators.Legislation & Policies, Regulations & Guidance.Data & Research Subnav: Data & Research 1.Airport Safety Information Video Series.Passenger Facility Charge (PFC) Program.Airport Coronavirus Response Grant Program.General Aviation & Recreational Aircraft.Vintage & Experimental Aircraft Program.

Aviation Safety Draft Documents Open for Comment.

Aircraft aluminum tubing bend radius chart